Blodgett KTT-DS Series User Manual download pdf (Page 9)

OM-KTT-DS 7

Initial Start-Up

Now that the kettle has been installed, you should test it to ensure that it is operating

correctly.

1. Remove all literature and packing materials from inside and outside of the unit.

2. Pour a small amount of water into the kettle.

3. Open the steam inlet valve.

4. When the water begins to boil, inspect all of the ﬁttings to ensure that there are

no leaks.

5. Check the safety valve by lifting its lever far enough to let steam escape. Then

let it snap back into place to reset the valve so that it will not leak.

6. Shut down the unit by closing the steam inlet valve.

7. Operate the tilting mechanism to conﬁrm that this feature functions through the

whole range of normal operation.

If the unit functions as described above, it is ready for use. If the unit does not function

as intended, contact your local Certiﬁed Service Agency.

IMPORTANT

BE SURE ALL OPERATORS READ,

UNDERSTAND AND FOLLOW THE

OPERATING INSTRUCTIONS, CAUTIONS,

AND SAFETY INSTRUCTIONS CONTAINED

IN THIS MANUAL.

WARNING

AVOID ANY EXPOSURE TO ESCAPING STEAM,

WHICH CAN CAUSE SEVERE BURNS.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

No comments

Blodgett KTT-DS Series User Manual Page 9