Blodgett KTT-DS Series User Manual Page 15

  • Download
  • Add to my manuals
  • Print
  • Page
    / 20
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 14
OM-KTT-DS 13
Troubleshooting
Your kettle will operate smoothly and efciently if properly maintained. However, the following is a list of checks to make in the event
of a problem. If the actions suggested do not solve the problem, call your qualified Service Representative. If an item on the list is
followed by X, the work should be done by a qualified service representative.
SYMPTOM WHO
WHAT TO CHECK
X indicates items which must be performed by an authorized technician.
Kettle will not heat. User a. That the steam inlet valve is open.
b. That the steam supply line is turned on.
c. That the condensate return valve is open.
d. That the boiler is operating properly. Steam should be
supplied at a pressure greater than five PSI.
Auth Service
Rep Only
e. Steam supply line for blockage. X
f. Condensate return line for blockage. X
g. Steam trap operation. X
Safety valve leaks a small
amount of steam.
User a. For contamination that prevents seating the valve. With
pressure in the jacket, lift the valve lever briefly all the way up,
to blow the valve clean then let it snap back down to seat the
valve.
Auth Service
Rep Only
b. Safety valve for defects. Defective valve MUST be replaced
with an identical valve. X
Safety valve leaks a large
amount of steam.
Auth Service
Rep Only
a. Steam supply pressure. X
b. Safety valve for defects. Defective valve MUST be replaced
with an identical valve. X
Pipe fitting leaks. User a. Is the fitting tight?
Auth Service
Rep Only
b. If the leak is at a trunnion, and tightening the packing gland
does not stop the leak, replace the packing. X
WARNING
USE OF ANY REPLACEMENT PARTS OTHER THAN THOSE SUPPLIED BY AN AUTHORIZED SUPPLIER/DISTRIBUTOR
WILL VOID ALL WARRANTIES AND COULD INJURE THE OPERATOR OR DAMAGE THE EQUIPMENT.
TO AVOID INJURY FROM SPLASHING OR SPILLING HOT CONTENTS, EMPTY THE KETTLE THROUGH THE DRAWOFF
OR BY BAILING BEFORE ANY WORK IS DONE ON THE TILTING MECHANISM.
Page view 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments