Blodgett SN-5G User Manual download pdf (Page 9)

ELECTRICAL CONNECTION

WARNING: Do not connect the appliance to the electrical supply until after the gas

connection has been made.

120 VAC-60 Hz-Single Phase

Units with this electrical rating are factory supplied with a three-wire cord and three-

prong plug which fits any standard 120V, three-prong grounded receptacle. A separate

15 amp supply is needed for each unit.

PLUMBING CONNECTIONS

WARNING: Plumbing connections must comply with applicable sanitary, safety and

plumbing codes.

Two water lines are provided, one for each compartment. Connect water supply line to

the 3/8" copper tube in at the rear of the steamer. The 3/8" copper tube supplies water

to both the generator tank and to condense live steam entering the drain line.

DRAIN CONNECTIONS (FIGURE 2)

The drain connection must be 1" IPS

vertically down, preferably with one elbow

only, and maximum length of 6 feet, piped

to an open air gap type drain.

CAUTION: In order to

avoid any back pressure

in the steamer, do not

connect solidly to any

drain connection.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

No comments

Blodgett SN-5G User Manual Page 9